La Pavoni BAR AT ES Mode D'emploi page 51

la Pavoni
- With the help of a vacuum cleaner remove the beans from
the g rinder' s inlet (fig . 16).
fig. 16
- Firstly remove the four screws (ref.
geared wheel (ref. D, fig. 17).
C
C
fig. 17
- Completely unscrew the adjustment ring nut (ref.
18) and clean both the grinders using a vacuum cleaner
and a brush.
Important
Verify furthermore the wear of the grinders as well as
any damage they might have suffered and, if
necessary, replace them.
fig. 18
C, fig. 17), then the
C
C
D
E, fig.
E
To assemb le the cof fee g rinder it is necessar
- Completely screw the adjustment ring nut (ref.
then unscrew it by half a turn.
Important
This last operation is necessary both to avoid the
jamming and to prevent damaging the grinders.
E
fig. 19
- Re-position the geared wheel (ref.
tightening the screws (ref.
C
C
E
fig. 20
- Re-position the cof fee hopper (r ef. 1, fig . 21) b y fir st hoo-
king the front part and then rotating it downwards.
Important
Attention should be paid to the positioning of the
gasket (ref. F, fig. 21) which must fit properly in the
geared wheel (ref. D, fig. 21) and the ring nut (ref. E,
fig. 21).
Engl i s h
y to:
E, fig. 19),
D, fig. 20) and lock it by
C, fig. 20).
C
C
D
51