Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
la Pavoni
8 -
TROUBLESHOOTING -
CAUSES AND REMEDIES
The following table lists a number of troubles that may occur
during the working life of the machine.
When the symbol
appears in the "remedy" column it
means that the intervention must be carried out by the
Mai n tenance techni c i a n.
TROUBLE
The machine does not switch on
Display shows message
"EMPTY GROUNDS"
Grinding error
Instead of coffee only water is di-
spensed
No water or steam are dispensed
The coffee is dispensed too quickly
The coffee is dispensed too slowly
The coffee isn't hot enough
The coffee is not creamy enough
Machine takes too long to heat up,
the water delivery is very limited
The dispensing unit cannot be re-
moved
The dispensing unit cannot be in-
serted
CAUSE
The machine is not powered up
The grounds tray is full
The cof fee g rinder is jammed
The pr e-g round cof fee selection k
been pr essed b ut no po w der cof fee w as
inserted in the relevant slot
The hole of the steam/hot water spout is
cl o gged up
Grinding is too coarse
Grinding is too fine
The cup is not pre-heated
The machine has not reached yet the cor-
rect temperature
The b lend is not suita
ble , the cof fee is not
fr eshl y r oasted, and the g round cof fee is
either too fine or too coarse
The machine circuit is clogged up by lime-
stone
The cof fee dispenser unit is not in its pr
per base position (N)
The cof fee dispenser unit is not in its pr
per base position (N)
REMEDY
Check that the plug is connected
Check that the multi-pole switch (if pre-
sent) is on
Check the electrical circuit fuses
Check electrical connections
Empty the grounds tray and refit it correctly
Clean the coffee grinder
(see "7.3 Jamming of coffee grinder")
Insert the dose in the slot and repeat the
ey has
cycle
Clean with a fine needle
Adjust it on finer grinding
Adjust it on coarser grinding
Pre-heat the cup on the heating plate
Wait for correct temperature to be reached
Change coffee blend or check the grinding
(if pre-ground)
Descale machine
o-
Switch machine off and on through the
main switch
o-
Manually rotate the unit until the basic
position (N) is reached. Make the mark on
the shaft coincide with arrow N (see fig.
13)
Engl i s h
53
Publicité
Table des Matières
