Sulky Burel XEOS MD Notice Originale page 35

Start-up
K I
Tractor control
- To be checked:
• The total authorised weight.
• The permitted weight per axle.
• The authorised support weight on the tractor's linkage.
• The permissible load capacity for the tyres fitted to the tractor.
• Is the authorised linkage weight sufficient?
All of this information can be found on the registration papers, or on the data plate and in the tractor manual.
F
IGURES THAT YOU SHOULD KNOW
P Kg Unladen weight of tractor
P1 Kg Weight on the front axle when the tractor is empty
P2 Kg Weight on the rear axle when the tractor is empty
M1 Kg Total weight of front ballast
M2 Kg Weight of the rotary harrow or of the tool
M3 Kg Weight of the drill + seed
Distance between the centre of gravity of the
a m
front ballast and the centre of the front axle
b m Wheelbase of tractor
Distance between the lower linkage pins and the
c m
centre of the rear axle.
Distance between the lower linkage pins and the
d m
centre of gravity of the machine
Distance of the centre of gravity from the rotary
d2 m
harrow
d3 m Distance of the centre of gravity of drill + seed
M1 mini = Calculation of the minimum ballast need in front.
Pc = Calculation of the total weight of the unit (tractor + machine)
calculated
P1c
P2c
Pc
- Complete the table below:
- Check that:
• The values calculated should be < or = to the tractor's permissible values and the values for the tyres fitted to the tractor.
• It is essential that the minimum load on the front axle is > or = to 20% of the unladen tractor weight.
The machine must not be hitched to a tractor if:
The total weight calculated is > than the maximum authorised weight.
The weight on the front axle is < than the minimum required.
Values
Consult the tractor's instruction manual or the registration
documents.
Consult the technical characteristics of the tractor and the
front ballast, or measure.
Consult the technical characteristics of the rotary harrow or
of the tool
Consult the machine's technical characteristics.
(see section 5 "Characteristics").
Consult the technical characteristics of the tractor and the
front ballast, or measure.
Consult the instruction manual or the tractor's registration
documents, or measure.
Consult the machine's technical characteristics.
(see section 5 "Characteristics").
P1c = Calculation of the weight on the front axle
P2c = Calculation of the weight on the rear axle
Tractor's
permissible values
Values permissible with
the tyres that are
fitted to the tractor
EN
2
33