Reduction Ratio Setup Menu - CASTELLINI SKEMA 6 Instructions De Service

5.5.4 Reduction ratio setup menu

Select the icon for "Reduction ratio setting" on the menu used to set the
operating data and press the right multifunction button (
submenu containing the following icons:
Current reduction ratio
Maximum speed that can be reached with selected reduction ratio
NOTE:: icon Rpm cannot be edited as it only shows the maximum
speed that can be reached with the reduction ration selected above.
How to change the current reduction ratio:
• Use buttons INCREASE and/or DECREASE to scroll the saved reduction
ratios.
NOTE: the fast selection buttons can be used to set the preset
values that vary according to the current operating mode.
• To confi rm the selections made, simply quit this submenu by pressing mul-
tifunction button ESC.
How to create customized reduction ratios:
Follow the directions given below to create and save customized reduction
ratios.
• Press the right multifunction button (NEW).
• Press buttons INCREASE and/or DECREASE to modify the tenths.
• Press the MAX and/or MIN fast selection buttons to change the units.
• Once the desired reduction ratio has been set, press the right multifunction
button ( ) to save it.
How to edit and/or delete customized reduction ratios:
NOTE: Only customized reduction ratios can be edited and/or
deleted.
• Press buttons INCREASE and/or DECREASE to scroll the saved reduction
ratios.
• Press the MENU button (EDIT) to change over to editing mode.
• Press buttons INCREASE and/or DECREASE to modify the tenths.
• Press the MAX and/or MIN fast selection buttons to change the units.
• Press the right multifunction button (
• Press the left multifunction button (
SKEMA 6
- OPERATING INSTRUCTION
) to go to the
) to save it again.
) to delete.
GB GB 111 111 111