Horizon Hobby ARF Hangar 9 Manuel D'utilisation page 27

11. Slide four M5 washers on four M5 x 20 socket head cap screws
Slide the screws through the holes in the rear of the motor box, then
into the holes in the fuselage fi rewall. The screws use a 4mm hex
wrench to tighten.
12. Place a drop of thread lock on the end of each screw, then thread an
M5 fl anged nut on each screw. Use the 4mm hex wrench and 8mm
nut driver to tighten the hardware.
13. Attach the X-mount to the motor. Place a drop of thread lock on
each of the screws provided with the motor, then use a #2 Phillips
screwdriver to tighten the screws attaching the mount to the motor.
14. Attach the motor to the motor box using four M5 x 15 socket head
cap screws, four M5 washers and four M5 blind nuts. Place a drop
of thread lock on each screw before their installation. Tighten each
screw using a 4mm hex wrench.
15. Mount the speed control to the motor box following any instructions
provided with the speed controller. Connect the leads from the motor
and speed control and secure them using tie wraps so they don't
interfere with the operation of the motor.
Fokker D.VII 30–60cc ARF
16. Guide the leads for the battery and receiver through the hole in the
fuselage fi rewall.
17. Secure the batteries to the battery tray using the hook and loop
straps provided with the kit. We recommend applying hook and loop
tape to the battery tray and batteries to keep the batteries from
sliding when installed in the fuselage.
 Do not cover safety warnings on the
battery with hook and loop tape.
18. Install the battery tray in the fuselage by fi tting the notch at the front
into the slot in the fi rewall. Use the nylon M4 x 20 screw to secure
the rear of the battery tray.
 The test aircraft were flown without the addition of nose
weight using the following motor and battery combinations:
Motor Propeller
Rimfi re 65 cc 24x10
Rimfi re 160/170 20x8 or 20x10
27
Battery
6S 7000mAh x2
5S 5000mAh x4
* Two packs in
parallel to equal 10s
10000mAh
EN