Housing Serial Port Menu; Polarity Menu - Videotec ULISSE MAXI Manuel D'instructions

10.1.6 Housing Serial Port Menu

Once you have exited from the camera
OSM, press the Iris Close key to return to
the Pan & Tilt OSM.
To prevent the camera OSM from
overlapping the Pan & Tilt OSM, exit from
the camera configuration mode before
pressing the Iris Close key.
1. Protocol: It allows you to choose the protocol
used in the housing serial.
2. Baud Rate: It allows you to choose the baud
rate used in the housing serial.
3. Return Cmd: It replaces the Confirm control
provided with the joystick with a customised
option.
Exit Cmd: It replaces the Exit control provided
4.
with the joystick with a customised option.
Enable Camera OSM: Allows access to the
5.
camera configuration mode.
HOUSING SERIAL PORT
------------------------
1>PROTOCOL
2 BAUDRATE
3 RETURN CMD: IRIS CLOSE
4 EXIT CMD
5 ENABLE CAMERA OSM
Fig. 97
MNVCUPTMAXB_1511_EN
: NONE
: 9600
: IRIS OPEN
>

10.1.7 Polarity Menu

It allows you to configure the following parameters:
Zoom: It allows you to choose the motor
1.
rotation polarity of the lens Zoom.
2. Focus: It allows you to select the motor rotation
polarity of the lens Focus.
3. Iris: It allows you to select the motor rotation
polarity of the lens Iris.
POLARITY
------------------------
1>ZOOM :
2 FOCUS:
3 IRIS :
Fig. 98
POSITIVE
POSITIVE
POSITIVE
45