Installation; How To Open The Housing; How To Install The Camera - Videotec HTG Manuel D'instructions

6 Installation

6.1 How to open the housing

Unscrew the screws on the rear cover plate and
loosen the 2 dowels on the outer slide. Slide out the
housing body.
Fig. 1
After installation and wiring, close the
product again.
6

6.2 How to install the camera

Power supply can be provided by the board
supplied with the product. Make sure the
voltage values are appropriate.
Open the housing as described in the relative chapter
(6.1 How to open the housing, page 6).
Fasten the camera with the 1/4" screw (01). To
position the camera and lens correctly, if necessary,
use the supplied spacers. (02).
Fig. 2
Remove the conductors protective sheathing and
connect them to terminal (camera power supply, 6.3
Board description, page 7).
The camera's power supply cable conductors must be
tied up with a cable tie next to the terminal. Keep the
signalling and power supply cables separated from
each other.
Reposition the internal slide and tighten the screws
that had been loosened previously.
02
01
MNVCHTG_2104_EN