Identification; Product Description And Type Designation; Product Marking; Preparing The Product For Use - Videotec HTG Manuel D'instructions

4 Identification

4.1 Product description and type
designation
This housing has been designed to fit thermal
cameras with large lenses for vision even in total
darkness, fog, rain and smoke, or for long distances.
It can be used for a wide range of day/night
surveillance systems, such as monitoring and
rescue in the event of a fire, public safety or airport,
industrial and environmental surveillance.
The opening system allows an easy access for
installation and servicing.
It can be installed with cable sheaths, instead of
regular cable glands using the junction box for the
wiring harness.

4.2 Product marking

See the label attached to the product.
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.

5.1 Safety precautions before use

CAUTION! The electrical system to which
the unit is connected must be equipped
with a 15A max automatic bipolar circuit
breaker. The minimum distance between
the circuit breaker contacts must be
3mm (0.1in). The circuit breaker must be
provided with protection against the fault
current towards the ground (differential)
and the overcurrent (magnetothermal).
MNVCHTG_2104_EN

5.2 Unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
5.3 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Housing
• Housing equipment:
• Allen wrenches
• Spacers
• Bolts and screws
• Desiccant bag
• Instruction manual
5.4 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
5.5 Preparatory work before
installation

5.5.1 Attaching the bracket

The product must be fastened with suitable
equipment. The fastening means must
guarantee the mechanical seal when a force
equal to at least 4 times the weight of the
device is applied.
5