Accessories; Heater; Heater Installation; Camera Power Supply - Videotec HTG Manuel D'instructions

7 Accessories

For further details on configuration and
use, refer to the relative manual.

7.1 Heater

7.1.1 Heater installation

At the end of istallation, connect the wiring to the
terminal (heater power supply, 6.3 Board description,
page 7).

7.2 Camera power supply

7.2.1 Camera power supply installation

Not usable in housings with wiper device
installed.
Pay attention to the voltage used to power
the circuit. Depending on requirements use
the correct power supply kit.
Usable power supplies:
• IN from 100Vac up to 240Vac, 50/60Hz - OUT
12Vdc, 1.25A
• IN 230Vac, 50Hz - OUT 24Vac, 50Hz, 400mA
Fig. 7 Camera power supply.
After installation, connect the power supply to
the connector (power supply connector, 6.3 Board
description, page 7).
MNVCHTG_2104_EN

8 Maintenance and cleaning

Before doing any technical work on the
device, disconnect the power supply.

8.1 Cleaning

8.1.1 Cleaning the window and plastic
parts
Avoid ethyl alcohol, solvents, hydrogenated
hydrocarbide, strong acid and alkali. Such
products may irreparably damage the
surface.
We recommend using a soft cloth with neutral soap
diluted with water or specific products to clean the
glasses lenses.
9 Disposal of waste
materials
This symbol mark and recycle system
are applied only to EU countries and not
applied to other countries of the world.
Your product is designed and manufactured with
high quality materials and components which can be
recycled and reused.
This symbol means that electrical and electronic
equipment, at their end-of-life, should be disposed of
separately from your household waste.
Please dispose of this equipment at your local
Community waste collection or Recycling centre.
In the European Union there are separate collection
systems for used electrical and electronic products.
9