Preset Menu (Utility Preset); Patrol Menu; Autopan Menu - Videotec ULISSE MAXI Manuel D'instructions

10.1.8.5 Preset Menu (Utility Preset)

It allows you to configure the following parameters:
1. Scan Speed: Speed used to reach the Preset
position after reception of a Scan control.
2. Default Speed: Preset default speed. This value
is used by function "Imponi Vel.?" (Force Speed)
to assign the same Preset speed.
Default Dwell Time: Preset default pause. This
3.
value is used by function "Imponi Pausa?" (Force
Pause) to assign the same pause to each preset.
Ramp Value: Start and stop times. The higher
4.
the number, the greater the acceleration/
deceleration during starting/stopping.
Set Speed?: To assign all Presets the same
5.
default speed.
Set Dwell Time?: To assign all Presets the same
6.
default dwell time.
PRESET UTILITIES
------------------------
1>SCAN SPEED
2 DEFAULT SPEED
3 DEFAULT DWELL
4 RAMP VALUE
5 SET SPEED?
6 SET DWELL TIME?
Fig. 104
48
: 20.00
: 10.00
: 3
: 12

10.1.8.6 Patrol Menu

1. First Preset: First preset of the Patrol sequence.
2. Last Preset: Last preset of the Patrol sequence.
3. Random Mode: Enables random execution. The
sequence is re-calculated on a continuous basis.
PATROL
------------------------
1>FIRST PRESET
2 LAST PRESET
3 RANDOM MODE
Fig. 105

10.1.8.7 Autopan Menu

Preset Outward Movement: Autopan initial
1.
position.
Preset Return Movement: Autopan final
2.
position.
AUTO-PAN
------------------------
1>PRESET OUTWARD:
2 PRESET RETURN :
Fig. 106
The Preset position approaching speed is
defined in the relative chapter (10.1.8.4
Preset Menu (Edit Preset), page 47).
: 1
: 250
: N
1
2
MNVCUPTMAXB_1511_EN