Led Illuminators Installation; Counterweight Removal; Fitting The Illuminator On The Bracket - Videotec ULISSE MAXI Manuel D'instructions

8.8 LED illuminators installation

To work properly both illuminators must be
installed together.
From Pan & Tilt, it is only possible to install
VIDEOTEC illuminators.

8.8.1 Counterweight removal

Undo the screws and remove the external
counterweights.
Fig. 46
8.8.2 Fitting the illuminator on the
bracket
Identify the front holes on the counter-weight
bracket.
Fig. 47
28
Place the fixings of the illuminator (01) on those of
the bracket (02).
Fig. 48
Tighten the screws and the washers previously
removed.
Fig. 49
Pay attention to the fixing. Tightening
torque: 6Nm.
02
01
01
02
MNVCUPTMAXB_1511_EN