Horizontal Assembly With Using Instalation Handles - VTS WING W100 Manuel D'installation, D'utilisation Et D'entretien

3.2.1. HORIZONTAL ASSEMBLY WITH USING INSTALATION HANDLES.

It is possible to assemble WING do the wall horizontally in two options:
OPTION I: Assembling handles with their arms faced downwards. In this option you should first screw the installation handles to
the wall (1) with intervals W1 for a 1m curtain (there are 2 installation hanles) and W1, W2 for 1.5m and 2m curtain (there are 3
installation handles) so that the handles' arms are levelled.
Then lift the curtain and assembly with using screws (2) M8x20 and plain washers (3). Tighten the screws (2) and close the
handle's covers (4).
ATTENTION! The minimum distance between the unit and the ceiling should be 0.3m.
W1 [mm]
WING W, E, C100
WING W, E, C150
WING W, E, C200
OPTION II: Assembling handles with their arms faced upwards.
Assembly consists in screwing brackets to the curtain (1). To mount the brackets to the curtain, with the housing upside down, punch holes (5) from the outside in the shields (4) using a hammer and a
screw. Click the shields on the brackers (1). Mount the brackets on the curtain using M8x20mm screws (2) and washers (3). This assembly option allows for mounting brackets to the curtain first, and
then screwing the entire housing to the wall.
ATTENTION! The minimum distance between the unit and the ceiling should be 0.1m.
W2 [mm]
772 -
507 772
921 910
27
EN