Assembly/ Disassembly Of Side Covers; Assembly Of Device - VTS WING W100 Manuel D'installation, D'utilisation Et D'entretien

WING W100-200
WING E100-200
WING C100-200
The range of the air jet - assembly height
- horizontal installation
fan speed
height of assembly [m]
WING W100, W150, W200
WING E100, E150, E200
WING C100, C150, C200
H2
H1
5-7 m/s*
2,2 m/s*
*air stream velocity [m/s]
EN
IMPORTANT! The heating output should be adjusted to the temperature inside the room, as well as the strength and direction of the wind outside. The primary criterion for the regulation of the
heating power is the temperature inside the room, near the door. Should a room thermostat be used, WING activates the heating mode, depending on the temperature settings.
IMPORTANT! Please consider additional factors that affect device operation.
Factors that have a negative effect on curtain operation
doors or windows that are constantly open in the room, thus creating a draft
constant and open access to staircases, available through the room, the chimney draft
effect

3.1. ASSEMBLY/ DISASSEMBLY OF SIDE COVERS

In order to remove the outlet grid you should carefully level the grid catches located with the use of a screwdriver and pull it away. Having installed the device and connected it to the electric
supply put the grid back by clicking it on the catches.

3.2. ASSEMBLY OF DEVICE

For directly instalation use the threaded sleeves (M8) in the top of decice.
IMPORTANT! The minimum distance between the unit and the ceiling should be 0.1m.
III II I
H3 H2 H1
3.7 2.9 2.3
3.7 2.9 2.3
4.0 2.9 2.3
H3
9,6-11 m/s*
7-9 m/s*
2,3 m/s* 2,3 m/s*
M8
- vertical installation
fan speed
width of the door [m]
WING W100, W150, W200
WING C100, C150, C200
Factors that have a positive effect on curtain operation
presence of awning, roofs etc. on the outer side of the door
use of revolving doors
26
III II I
H3 H2 H1
3.7 2.9 2.3
4.0 2.9 2.3
H1 H2 H3