Important; Built Into A Suspended Ceiling - VTS WING W100 Manuel D'installation, D'utilisation Et D'entretien

WING W100-200
WING E100-200
WING C100-200
Recommended safety devices and wires
Overload and short circuit protection
Differential current protection
Power wire cross-section
IMPORTANT! Control 0-10VDC: LiYCY 2x0,75 (shielded).
IMPORTANT! The specification of cables and protections refers to unbounded arrangement of cables (basic execution of the E installation according to the PN-IEC 60364-5-523 standard).
One should always abide by the local laws and recommendations concerning device connection.
WING is equipped with a terminal strip adjusted to an appropriate thickness of wires.
WING E100
WING E150-200
EN
WING E100 EC
WING E150-200 EC

IMPORTANT!

● It is recommended to connect wires to the terminal strip with previously clamped appropriate clip ends.
● Make sure that the space around the place where the air is sucked in by the curtains, as well as around the exhaust grid, is free of any structural elements of the building, which might
hamper the flow of air (e.g. suspended ceilings, covering development, ventilating ducts etc.).

3.4. BUILT INTO A SUSPENDED CEILING

The installation of WING air curtains in the suspended ceiling is only possible if the appropriate minimum installation dimensions are maintained.
Permitted installation configurations:
Device
1m
WING W100-200
1,5m 2m 1m
C6/6kA B16/3/6kA B20/3/6kA B25/3/6kA
IDN=30mA type AC lub A IDN=30mA type AC lub A
IN=16A
3x1,5mm 5x1,5mm
²
WING W100-200
WING C100-200
WING W100-200 EC
WING C100-200 EC
30
WING E100-200 WING C100-200
1,5m 2m 1m
IDN=30mA type AC lub A
IN=40A
5x2,5mm 5x4,0mm
² ² ²
1,5m 2m
C6/6kA
IN=16A
3x1,5mm
²