Ryobi RLM46160S Traduction Des Instructions Originales page 14

TROUBLESHOOTING
Problem
The handle is not in The handle is positioned incorrectly.
the correct position.
The handle knobs are not tightened.
The mower does There is no petrol.
not start.
The engine is fl ooded.
Old fuel
No spark.
The starter rope is harder to pull now
than when it was new.
The mower is hard The grass to be mowed is too tall.
to push.
The mower housing and blade is being
dragged through heavy grass.
The cutting height is too low.
T h e m o w e r i s The blade is unbalanced.
vibrating at a higher
speed.
The motor shaft is bent.
Mower not mulching Wet grass clippings sticking to
properly
the underside of the deck.
The grass catcher The discharge chute is blocked.
is not being filled
up with grass even
t h o u g h g r a s s i s
being cut from the
lawn.
Cutting height set too low.
12
Possible cause
.
Solution
Check and ensure that the lower part of handle is pushed
fully back and snapped into proper position.
Tighten the handle knobs.
Fill the mower with petrol. If the mower still does not start,
contact an authorised service centre.
Wait for 15 minutes, then try starting the mower again.
Refer to Starting/Stopping the mower section.
Only use fresh fuel. Fuel over 30 days old may prevent
the product from starting.
Check spark. Remove spark plug. Reattach the spark plug
cap and lay spark plug on metal cylinder. Pull the starter
rope and watch for spark at spark plug tip. If there is no
spark, repeat test with a new spark plug.
Contact an authorised service centre.
Raise the cutting height.
Replace the blade.
Stop the product. Make sure that all moving parts have
come to a complete stop. Allow the product to cool down.
Disconnect the spark plug wire. Inspect for damage. Have
the damage repaired by an authorised service centre
before restarting the product.
Wait until the grass dries before mowing.
Stop the product. Make sure that all moving parts have
come to a complete stop. Allow the product to cool down.
Disconnect the spark plug wire. Remove grass catcher
and lift discharge chute cover. Beware of the sharp blade
and avoid contact. Remove the debris from the discharge
chute.
Raise the cutting height. Cutting very wet grass at a low
cutting height will also greatly hinder the ability of the
mower to throw the grass to the catcher. We recommend
raising the cutting height or cutting the grass when it is
not as wet.
English