Publicité
Cool mode(+ 1°C/2°F) per hour
for the first two hours
Set
temperature
Heat mode ( -1°C/2°F) per hour
for the first two hours
Saving energy during sleep
NOTE: For multi-split appliances, the following functions are not available: Active clean function, Silence
feature, Breeze away function, Refrigerant leakage detection function and Eco feature.
Setting Angle of Air Flow
Setting vertical angle of air flow
While the appliance is on, use the SWING/DIRECT button on remote control to set the direction (vertical
angle) of airflow. Please refer to the Remote Control Manual for details.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set louver at too vertical an angle for long periods of time. This can
cause water to condense on the louver blade, which will drop on your floor or furnishings.
When using COOL or HEAT mode, setting the louver at too vertical an angle can reduce the performance of
the appliance due to restricted air flow.
NOTE: According to the relative standards requirement, please sets the vertical air flow louver to its
maximum angle under heating capacity test.
Setting horizontal angle of air flow
The horizontal angle of the airflow must be set manually. Grip the deflector rod (See Fig.B)
and manually adjust it to your preferred direction. For some appliances, the horizontal angle of the airflow
can be set by remote control. please refer to the Remote Control Manual.
Manual Operation(without remote)
CAUTION
The manual button is intended for testing purposes and emergency operation only. Please do not
use this function unless the remote control is lost and it is absolutely necessary. To restore regular
operation, use the remote control to activate the appliance. The appliance must be turned off
before manual operation.
SLEEP operation
1hr
1hr
Keep
running
4
153
Publicité
