Publicité
Les langues disponibles
Les langues disponibles
LIGHTING THE MAIN BURNERS:
•
Always open the Lid before lighting the grill.
•
All burner knobs should be in the "OFF" position.
•
Slowly Open the LP Gas Cylinder valve,1-1 1/2 turns
•
Push the gas knobs in fully, and slowly turn counter-clockwise (to the left) to the "HIGH" position.
•
Then press and hold the black button of the igniter, there will be clicking and sparking until the burner is lit.
•
You can then adjust the knob to your desired setting.
•
If the burner did not light, turn the knob back to the "OFF" position, wait 5 minutes for any gas to clear away, and then
repeat the lighting procedure.
•
After using the grill, turn all burner knobs to the "HIGH" position and then push fully in and turn to the "OFF" position.
•
At once turn the valve on the LP Gas Cylinder OFF.
•
IF the igniter does NOT light the burner, you can light it with a match or a piece of burning paper - hold the match or paper
with the Match Holder attached at the back of the grill, put it through the openings in the Cooking Grid and next to the
Flame Tent covering. Then follow the lighting procedure above.
•
Observe the proper burner flame - it should be a blue/yellow color about 1/2" long.
CAUTION: The cylinder valve should always be in the OFF, or closed position when the grill is not in use.
GAS BURNER KNOB
LOW
ELECTRIC SMOKER KNOB
Observe the proper burner flame.
It should be a blue/yellow color about 1/2" long.
MANUALLY LIGHTING THE GRILL:
1.
Open the Hood. IMPORTANT: Make sure control knob is turned "OFF".
2. While holding a lit match near the burner, push the control knob in and turn counterclockwise to the High position.
If burner goes out during operation, turn control knob to the "OFF" position. Open hood and wait five minutes before attempting
to relight the grill to allow any accumulated gas to dissipate.
OPERATING INSTRUCTIONS - GAS
LIGHT
Yellow
Good
Flame
Blue
OFF
OFF
Bad
Flame
31
Publicité
