Publicité
Les langues disponibles
Les langues disponibles
19. ATTACHING THE TEMPERATURE SENSOR INSIDE
THE SMOKER CABINET
Parts Required :
1
x
Temperature Sensor
Installation :
•
Insert the Smoker Temperature Sensor through the hole
on the top of the Smoker Cabinet.
•
Next attach it into the clip which is located inside top
area of the Smoker Cabinet.
See Fig. 19.1. Fig. 19.2 and Fig 19.3.
20. ATTACHING ELECTRIC WIRES ONTO TWO CLIPS
NEAR THE SMOKER CABINET, ATTACHING THE GAS
AND CHARCOAL CABINET ASSEMBLY ONTO THE
CART ASSEMBLY
Parts Required :
1
x
Electric Wires
1
x
Electric Wires Male Socket (end of the Electric Wires)
1
x
Electric Wires Female Socket
Gas and Charcoal Cabinet with Lids Assembly (#13)
1
x
1
x
Cart Assembly
8
x
M6x15 mm Screws (#A)
4
x
M6x10 mm Screws (#D)
Installation :
Note: The Main Chamber must be lined up to the Trolley.
•
Carefully open the lids and attach Gas and Charcoal
Cabinet Assembly (#13) to the Cart Assembly by first
fixing the 4 pcs M6x10 mm Screws (#D) on inside
first, then fix the other 8 pcs M6x15 mm Screws (#A)
later. Regulator can be taken out at the stage for later
assembly.
Use: 8 pcs M6x15 mm Screws (#A) and 4 x M6x10 mm
Screws (#D)
See Fig. 20.1, Fig. 20.1a, Fig. 20.1b.
•
Attach the Electric Wires onto two clips near the Smoker
Cabinet from the lower area of charcoal grill side and
then attach the Electric Wires Male Socket (end of the
Electric Wires) to the Female Socket which is located on
the back of Bottom Table.
See Fig. 20.2 and Fig. 20.3.
16
Fig.19.1
Temperature sensor
Fig.20.1
Regulator
Fig.20.1a
M6x15mm
View hole for leg
screws assembly
Fig.20.2
Electric
Wires
Fig.20.3
Male Socket
Fig.19.3
Fig.19.2
Inside top area of
Electric Smoker
M6x10mm
Fig.20. 1b
M6x15mm
View hole for leg
screws assembly
Female
Socket
View
hole
for leg
screws
Publicité
