Kübler Sendix 58 FS2 Instructions D'utilisation page 60

• All assembly steps described in chapter Installation [} 45]
can be performed.
6.4 Traceability
Identification of errors in the field
A traceability of these products is recommended. This can be
achieved for example by means of the serial number on the
type plate. Complete traceability is decisive for fast and tar-
geted reaction in the market
7 Disposal
Always dispose of unusable or irreparable devices in an en-
vironmentally sound manner, according to the country-spe-
cific provisions and in compliance with the waste disposal
regulations in force. We will be glad to help you dispose of
the devices, see chapter Contacts [} 64].
Environmental damage in case of incorrect disposal
Electrical waste, electronic components, lubricants and other
auxiliary materials are subject to hazardous waste treatment.
Problem substances and may only be disposed of by
licensed specialist companies.
Dispose of disassembled device components as follows:
• Metal components in the scrap metal.
60 - EN
NOTICE
NOTICE
• Electronic components in the electrical waste.
• Plastic parts in a recycling center.
• Sort and dispose of the other components depending on the
material type.
8 Annex
8.1 Requirements for an Encoder Evaluation
Device
Characteristic values of the encoder evaluation
device for FS2 encoders
Designation
Safety requirement
Diagnostic coverage DC
Error presumptions**
** see chapter Signal monitoring [} 62].
Characteristic values of the encoder evaluation
device for FS3 encoders
Designation
Safety requirement
Diagnostic coverage DC
Error presumptions**
BA Sendix® 58xxFS2 / 58xxFS3 - R60049.0009 - 04
Value
≥ SIL2 (compliant with
IEC 61508)
≥ 90 %
according to EN 61800-5-2
Value
≥ SIL3 (compliant with
IEC 61508)
≥ 99 %
according to EN 61800-5-2