Kübler Sendix 58 FS2 Instructions D'utilisation page 49

Clamping flange, solid shaft with flat
3xM3, 6 [0.24] deep
3xM4, 8 [0.32] deep
4.1.3.1.1 Assembly Instructions for Solid Shaft
Encoders
a) Fasten the encoder using three M3 screws in the tapped
holes provided in the flange.
b) Tighten the screws with a 1 Nm [0.74 ft-lb] torque.
c) Check the shafts for offset. The maximum permissible tol-
erances depend on the selected shaft coupling.
BA Sendix® 58xxFS2 / 58xxFS3 - R60049.0009 - 04
d) Connect the encoder and drive shafts via a tolerance-com-
e) During assembly, protect the tolerance-compensating ele-
18014398571060491
f) Align the coupling on the shafts, screw the coupling
g) Secure the screws against loosening, see chapter
4.1.3.2 Hollow Shaft Encoders
Di-
men-
sion
a
d = Shaft
diameter
10 [0.39]
12 [0.47]
14 [0.55]
pensating element (coupling).
ment against too important bending and damages.
without preload.
Screw Retention [} 53].
5834FS 5873FS
Incremental Singleturn
Absolute
56 [2.2] 56 [2.2]
Shaft fit
H7
83087371
5883FS
Multiturn
Absolute
67,5 [2.66]
L = Shaft inser-
tion depth
> 34 [1.34]
EN - 49