Kübler Sendix 58 FS2 Instructions D'utilisation page 51

Threaded rod
In case of high efforts (e.g. high rotary speeds and reversing
operation), the threaded rod can suffer wear and must be in-
spected periodically. In this case, replacing the threaded rod /
the torque stop may become necessary.
• Make sure to oversize the fastening in the motor flange.
• The threaded rod must be secured against loosening.
Flange with rigid torque stop
SW 3
BA Sendix® 58xxFS2 / 58xxFS3 - R60049.0009 - 04
NOTICE
18014398571079051
Check the threaded rod regularly
Under high loads, the threaded rod of the torque stop can be
subject to a certain wear (e.g. in case of high rotational
speeds with reversing operation).
• Depending on the range of application, check the threaded
rod regularly.
• In the event of wear, immediately replace the threaded rod
and the torque stop.
• Comply with the maximum permissible shaft offset.
4.1.3.2.1 Assembly Instructions for Hollow Shaft
Encoders
a) Slide the encoder on the shaft.
b) Comply with the minimum and maximum insertion depth of
the shaft in the encoder.
c) Comply with the maximum permissible shaft offset.
NOTICE
83084939
EN - 51