Fitting The Wall Mounting Bracket; Suction Nozzles; Attaching / Removing The Suction Nozzles - DS Produkte PC-P002W-2 Mode D'emploi

Fitting the Wall Mounting Bracket

CAUTION!
■ Select a dry place that is out of the reach of children for the wall mounting bracket.
■ Before drilling the hole for the wall mounting bracket, ensure that there are no
cables/pipes in the wall that could be damaged.
You can hang the device on the wall for storage. For this purpose, you will fi nd a wall
mounting bracket with fastening material supplied with the device. Attach the wall
mounting bracket close to a plug socket if possible so that it is easier for you to charge
up the battery when the device is not being used.
1. Hold the wall mounting bracket against the chosen location. The hook must be point-
ing upwards.
2. Mark a hole for drilling with a pencil.
3. Drill the hole and insert the dowel supplied.
4. Fasten the wall mounting bracket to the wall with the screw supplied.
5. You can now hook the device into the wall mounting bracket. There is a slot for this
purpose on the bottom of the main unit (8). Charge up the battery if necessary (see
the "Charging up the Battery" chapter).

Suction Nozzles

Overview
• Nozzle with scraper lip (6): You can use this nozzle to suck up dirty water from
smooth surfaces such as windows, tiles or mirrors.
• Brush nozzle (10): Use the brush nozzle to remove dust from delicate objects such
as picture frames, lamp shades, keyboards, books etc.
• Crevice nozzle (11): Use the crevice nozzle to vacuum in folds in fabrics, corners,
recesses or other places which are hard to reach.
• Nozzle for sucking up liquids (12): You can use this nozzle to suck up small quanti-
ties of liquids (e.g. spilt mineral water).

Attaching / Removing the Suction Nozzles

21
• Plug the nozzle you want as far as it will go into the suction
opening (5) on the front of the collecting container (4) and
check that it fi ts securely. The locking mechanism of the
nozzle with scraper lip (6) must be heard to lock in place.
• To remove a suction nozzle, pull it out of the suction open-
ing. In the case of the nozzle with scraper lip, the release
button (7) must be pressed at the same time.
EN