Attaching The Wall Bracket; Assembly; Attaching / Removing Nozzles; Removing / Inserting The Dust Container - DS Produkte PC-P008E Mode D'emploi

Attaching the Wall Bracket

PLEASE NOTE!
■ Use the fastening material supplied to hang up the wall bracket. If you are unsure
whether the fastening material supplied is suitable for your wall, seek advice from a
specialist stockist.
■ Hang the wall bracket in a secure and solid place.
■ Before drilling, ensure that there are no pipes or cables behind the intended drilling
point.
1. Place the wall bracket (10) on the wall and mark three drill holes (two at the top and
one at the bottom).
2. Drill holes into the wall and insert wall plugs.
3. Screw the wall bracket onto the wall.

Assembly

Attaching / Removing Nozzles

With the exception of the turbo nozzle (3) and the turbo upholstery nozzle (4), all nozzles
are attached with the aid of the nozzle adapter (2).
• Plug the nozzle adapter into the suction opening (20) or the extension tube (1). Plug
the nozzle you want onto the nozzle adapter.
• To take them apart, pull the nozzle and the adapter apart.
Attaching / Removing the Turbo Nozzle, Turbo Upholstery Nozzle
and Extension Tube
No adapter is required for the turbo nozzle (3), the turbo upholstery nozzle (4) and the
extension tube (1).
• They are plugged directly onto the suction opening (20). The catches must be heard
to engage in place. Attach the turbo nozzle or the the turbo upholstery nozzle to the
extension tube in the same way.

Removing / Inserting the Dust Container

closed
open
23
• To detach it, press the release button (12) and pull the
turbo nozzle, the turbo upholstery nozzle or the extension
tube out at the same time.
• Removing: Twist the dust container (19) a little bit. It is re-
leased from the motor unit (16) and can be removed.
• Inserting: Insert the dust container into the motor unit. Ro-
tate it slightly as you do this until it engages in the motor unit
correctly. Then twist the dust container in the motor unit to
secure it in place. The release button of the dust container
must be located below the suction opening (20) after it has
been attached.
EN