Use; Cleaning And Storing The Device - DS Produkte PC-P008E Mode D'emploi

EN

Use

PLEASE NOTE!
■ Make sure that there are no large, pointy objects on the area to be cleaned.
■ Always switch off the device before replacing any accessories.
■ Pay attention to the dust container's MAX mark. If the mark is reached during use,
empty the dust container. Empty and clean the dust container after each use. The
fi lter must also be cleaned regularly to prevent the motor from being overloaded.
■ Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge. Charge up the battery after use
(see the "Charging Up the Battery" chapter).
■ Do not use the device when it is connected to the mains adapter.
• When the device is switched on, the charge status of the battery (8) is indicated
by the two green battery charge status lamps (13). If both lamps are lit up, the
battery is full. If only the red operating lamp (13) is lit up, the battery needs to
be charged up.
• If the suction power diminishes even though the battery is full, empty the dust
container (19).
• If the device is not going to be used for a lengthy period, take out the battery!
1. Select an accessory as required (see the "Device Overview" chapter, "Accessories"
section) and attach it to the device (see the "Assembly" chapter).
2. Switch on the device. To do this, press the On / Off switch (14).
– If it is only pressed lightly, the device automatically switches off again after it is
released. This is suitable for brief operation.
– For longer operation, press the On / Off switch down fully. The device then remains
switched on even after you let go of the switch. To switch off the device, the On /
Off switch must be pressed again.
3. Guide the nozzle over the surface to be cleaned.
4. After vacuuming, switch off the device, then empty the dust container and clean it if
necessary (see the next "Cleaning and Storing the Device" chapter).

Cleaning and Storing the Device

PLEASE NOTE!
■ Switch off the device before you clean it.
■ Keep the motor unit, the charging station, the mains adapter, the turbo nozzle and the
turbo upholstery nozzle away from water or other liquids to prevent electric shocks.
■ Do not immerse the HEPA fi lter in water or rinse it under running water to prevent
damage to the fi lter. It is neither machine-washable, dishwasher-safe nor suitable for
tumble drying.
■ Accessories that are cleaned with water must be completely dry when they are in-
serted back into the device!
■ Do not use any sharp or abrasive cleaning agents or cleaning pads. These could
damage the surfaces.
24