Attaching The Handle To The Device; Assembling The Device; Use; Preparing The Carpet - DS Produkte Z 01096 Mode D'emploi

Attaching the Handle to the Device

You will need a cross-head screwdriver.
1. Take the handle (14) and unscrew both screws from the bottom ends of the handle.
2. Insert the handle onto the adapter of the centre piece (13) and screw the screws back into
the boreholes.

Assembling the Device

Use

Preparing the Carpet

1. Thoroughly vacuum clean the carpet to be treated with a vacuum cleaner. Use a brush
adapter for this (if possible).
2. If possible, remove all furniture from the carpet. Place a plastic tarp under or around the
legs of large pieces of furniture that can't be moved aside and only remove the tarp once
the carpet is completely dry after cleaning. Otherwise the wet carpet could damage the legs.
3. Check the carpet's colour-fastness. Dip a piece of white fabric in the enclosed cleaning
solution and carefully rub it on a hidden part of the carpet. If the white fabric does not
discolour, you can clean the carpet with the device. For multicoloured carpets, test every
colour for colour-fastness.
1. Lay the dirty water reservoir (11) in the base (10) of the device
and fold down the handle of the reservoir (12) until it audibly
engages.
2. Insert the fresh water reservoir (6) into the centre piece (13).
First insert the valve into the round depression on the backside
of the device and then press the top of the reservoir against the
centre piece until it audibly engages.
3. Turn the lower hooks of the cable reel (3) downward and wrap
the mains cable around both hooks of the cable reel.
4. Your carpet cleaner is now ready for operation.
19