Inserting / Removing The Telescopic Tube; Adjusting The Length Of The Telescopic Tube; Attaching / Removing The Suction Nozzles; Removing / Inserting The Dust Container - DS Produkte VC-1101-S-3 Mode D'emploi

Inserting / Removing the Telescopic Tube

Adjusting the Length of the Telescopic Tube

Attaching / Removing the Suction Nozzles

Removing / Inserting the Dust Container

• Insert the open end of the handle (1) in the larger opening of
the telescopic tube (3). Rotate the handle lightly back and forth.
Finally check the connection for tightness.
• To remove the telescopic tube, detach it from the handle.
1. Press the slide (6) on the telescopic tube downwards and adjust
the tube to the desired length.
2. Release the slide and move the tube slightly until it engages.
• Plug the free end of the telescopic tube into the suction nozzle
to the limit stop. Rotate the nozzle lightly back and forth.
• You can also leave off the telescopic tube and plug the suction
nozzle directly onto the handle on the suction tube.
• To remove a suction nozzle, simply pull it off.
• Removal: Press the Release button (5) of the dust container and
pull it up out of the device by the carrying handle (4).
• Insertion: Pick up the dust container using the handle and
fi rst insert the container base into the device (the base points
downwards and the handle points upwards). Then press the
handle against the device housing, until the dust container
audibly clicks into the locking device. Hold the device on the
carrying handle and lift it to check whether the dust container
is positioned correctly.
23