Removing / Inserting The Dust Container; Use - DS Produkte Z 08183 Mode D'emploi

Removing / Inserting the Dust Container

Use

ATTENTION!
■ During use, always keep the nozzles away from body parts or animals and don't
reach into the nozzles. You/they could be caught in the vacuum cleaner or injured.
If something does get caught in the vacuum cleaner, immediately turn off the device
( push the On/Off switch).
■ Only turn on the vacuum cleaner once you are sure that all parts have been com-
pletely assembled and that all fi lters are correctly inserted.
■ To ensure that the mains cable does not heat up during operation, pull at least two
thirds of its entire length out of the device housing before switching on the vacuum
cleaner. In order to avoid damage do not tug out the mains cable as far as it will go
(no further than the red mark on the cable)!
■ Always turn off the device and pull the mains plug out of the socket before you
change a nozzle or attach or remove any other accessories!
■ Do not under any circumstances vacuum up the following:
– liquids or wet materials (such as wet carpet shampoo)
– smouldering ashes, cigarette butts, matches etc.
– fl ammable or ignitable materials
– very fi ne dust (e.g. cement dust), ash or toner
– hard, pointy objects such as larger glass shards
1. If you have not already done so, attach the desired suction nozzle to the telescopic
tube or suction hose (see chapter "Assembly", section "Mounting/removing suction
nozzles").
2. Pull the mains cable out of the housing, ideally as far as the yellow mark but in any
case no further than the red mark on the cable!
3. Insert the mains plug in a properly installed socket that is easily accessible.
4. Press the On/Off switch to turn the vacuum cleaner on.
5. Move the nozzle over the surface you want to clean. You can pull the vacuum clean-
er like a sled when vacuum cleaning.
19
• Removing: Press the
lease button on the dust con-
tainer handle and remove the
dust container.
• Inserting: Place the closed
dust container onto the motor
unit. Press the dust container
handle against the housing
until it engages audibly.
EN
re-