Assembly - DS Produkte Z 08183 Mode D'emploi

EN

Assembly

ATTENTION!
■ Risk of suffocation! Keep the packaging material away from children and animals.
■ Make sure that the device is not connected to the mains electricity supply before you
attach or remove the accessories.
1. Unpack all parts and make sure that the product contents are complete (see chapter
"Items Supplied and Device Overview") and check for any damage from transport.
If you identify damage to the components, do not use them (!), instead contact our
customer service centre.
2. Before using the device, remove all packaging materials and any labels and trans-
port restraints that may be on the device and are used for protection during trans-
portation or for advertising.
3. Attach the suction hose, the telescopic tube and a suction nozzle to the motor unit
(see below).
Inserting / Removing the Suction Hose
Inserting/removing the telescopic tube
Adjusting the length of the telescopic tube
Attaching / Removing Suction Nozzles
18
• Plug the connection piece of the suction hose into the suc-
tion intake opening. It must engage properly.
• To remove the suction hose, press the release buttons on
the connection piece and pull it off.
• Insert the open end of the handle into the corresponding
opening of the telescopic tube. At the same time twist the
handle gently backwards and forwards. Afterwards, check
the connection for secure seating.
• To remove the telescopic tube, pull it out of the handle.
• Push the slider on the telescopic tube and set the desired
length.
• Release the slider and move the tube forward until it locks
into place.
• Plug the free end of the telescopic tube as far as it will go
into one of the suction nozzles supplied. Twist the nozzle
back and forth slightly as you do this.
• For greater fl exibility, the suction nozzles can also be
plugged directly onto the handle of the suction hose, with-
out the telescopic tube.
• To detach a suction nozzle, pull it off.