Assembly; Operation - DS Produkte 06259 Mode D'emploi

EN
6. First disconnect the mains adapter from the mains power and then disconnect the
barrel connector from the charging station.
7. Remove the battery from the charging station.

Assembly

Attaching / Removing Nozzles
With the exception of the electrical fl oor nozzle (9), all nozzles are attached with the aid
of the nozzle adapter (12).
• Plug the nozzle adapter into the suction opening (8) or the extension tube. Plug the
nozzle you want onto the nozzle adapter.
• To take them apart, pull the nozzle and the adapter apart.
Attaching / Removing the Floor Nozzle and Extension Tube
No adapter is required for the electrical fl oor nozzle (9) and the extension tube.
• They are plugged directly onto the suction opening (8). The catches must be heard
to engage in place. Attach the electrical fl oor nozzle to the extension tube in the
same way.
Removing / Inserting the Dust Container
closed
open

Operation

PLEASE NOTE!
■ Make sure that there are no large, pointy objects on the area to be cleaned.
■ Pay attention to the dust container's MAX mark. If the mark is reached during use, emp-
ty the dust container. Empty and clean the dust container after each use. The HEPA fi lter
must also be cleaned regularly to prevent the motor from being overloaded.
■ Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge. Charge up the battery after use
(see the "Charging Up the Battery" chapter).
06259_07258_07833_09572_09847_DE-EN-FR-NL_A5_V14.indb 22 06259_07258_07833_09572_09847_DE-EN-FR-NL_A5_V14.indb 22
22
• To detach it, press the release button and pull the electrical
fl oor nozzle or the extension tube out at the same time.
• Removing: Twist the dust container (7) a little bit. It is re-
leased from the main unit (3) and can be removed.
• Inserting: Insert the dust container into the main unit. Ro-
tate it slightly as you do this until it engages in the main unit
correctly. Then twist the dust container in the main unit to
secure it in place. The release button of the dust container
must be located below the suction opening (8) after it has
been attached.
08.06.2021 16:15:29 08.06.2021 16:15:29