Nozzles; Assembly; Unpacking The Items Supplied; Inserting / Removing The Suction Hose - DS Produkte VC-1101-S-3 Mode D'emploi

Nozzles

CAUTION!
❐ Always switch off the vacuum cleaner fi rst before changing nozzles.
Floor Nozzle (7)
Crevice nozzle (12)

Assembly

Unpacking the Items Supplied

CAUTION!
❐ Danger of suffocation! Keep the packaging material away from children and animals.
❐ Make sure that the device is not connected to the mains power before you insert or remove
attachments.
Unpack all parts and check the items supplied for completeness (see the "Items Supplied and
Device Overview" chapter) and transport damage. If you fi nd any damage to the components,
do not use them (!), but contact the customer service department.

Inserting / Removing the Suction Hose

The fl oor nozzle is suitable for both carpets and hard fl oors.
The foot switch allows you to change between carpet and hard
fl oor. For hard fl oors, a brush is extended on the underside of
the nozzle.
The crevice nozzle is suitable for cleaning all nooks and crannies
that cannot be reached with the other nozzles. It has a brush
attachment (13) for cleaning delicate objects e. g. keyboards.
Put this attachment on the nozzle.
• Plug the thicker end of the connection piece of the suction
hose (11) into the suction intake opening (9) and turn it as far
as it will go in the direction of the dust container (10). It must
engage.
• To remove the suction hose, turn the connection piece as far
as it will go in the opposite direction of the dust container and
then pull out the suction hose.
22