Attaching The Wall Bracket; Assembly; Attaching / Removing Nozzles - DS Produkte XS-180050EU Mode D'emploi

d
6. First disconnect the mains adapter from the mains power and then disconnect the
barrel connector from the charging station.
7. Remove the battery from the charging station.

Attaching the Wall Bracket

PLEASE NOTE!
■ Use the fastening material supplied to hang up the wall bracket. If you are unsure
whether the fastening material supplied is suitable for your wall, seek advice from a
specialist stockist.
■ Hang the wall bracket in a secure and solid place.
■ Before drilling, ensure that there are no pipes or cables behind the intended drilling
point.
1. Remove the spacer from the wall bracket (6).
2. Place the spacer on the wall and mark three drill holes (two at the top and one at
the bottom).
3. Drill holes into the wall and insert wall plugs.
4. Press the spacer onto the wall bracket.
5. Screw the wall bracket with the spacer onto the wall.

Assembly

Attaching / Removing Nozzles

With the exception of the electrical fl oor nozzle (12), all nozzles are attached with the
aid of the nozzle adapter (2).
• Plug the nozzle adapter into the suction opening (21) or the articulated suction
tube (9). Plug the nozzle you want onto the nozzle adapter.
• To take them apart, pull the nozzle and the adapter apart.
Attaching / Removing the Floor Nozzle and Articulated Suction Tube
No adapter is required for the electrical fl oor nozzle (12) and the articulated suction
tube (9).
• They are plugged directly onto the suction opening (21). The catches must be heard
to engage in place. Attach the electrical fl oor nozzle to the articulated suction tube
in the same way.
2. Insert the battery into the charging station (5). The three
contacts of the battery must rest on the three contacts (a)
of the charging station.
3. First plug the barrel connector on the cable of the mains
adapter (4) into the socket (c) of the charging station and
then connect the mains adapter to the plug socket.
a
4. The green operating lamp (b) and the red charge control
b
lamp (d) will light up. The battery is being charged.
5. When only the green operating lamp is still lit, the battery
c
is fully charged.
23 EN