Removing / Inserting The Dust Container; Operation - DS Produkte XS-180050EU Mode D'emploi

EN

Removing / Inserting the Dust Container

closed
open

Operation

PLEASE NOTE!
■ Make sure that there are no large, pointy objects on the area to be cleaned.
■ Pay attention to the dust container's MAX mark. If the mark is reached during use,
empty the dust container. Empty and clean the dust container after each use. The
HEPA fi lter must also be cleaned regularly to prevent the motor from being overloaded.
■ Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge. Charge up the battery after use
(see the "Charging Up the Battery" chapter).
When the device is switched on, the charge status of the battery (7) is indicated
by the two green battery charge status lamps (14). If both lamps are lit up, the
battery is full. If only the red operating lamp (14) is lit up, the battery needs to be
charged up.
1. Select an accessory as required (see the "Device Overview" chapter – "Accesso-
ries") and attach it to the device (see the "Assembly" chapter).
2. Switch the device on. This can be done in one of two ways:
– by gently holding the On / Off switch (15) down. The device will switch off when
you let it go.
– by fi rmly pushing the On / Off switch once and then releasing it. If you would like to
switch the device back off, push the On / Off switch again.
3. The device will immediately start to vacuum clean. The operating lamp and the
battery charges status lamps are lit up.
4. Run the device over the area to be cleaned.
5. If the articulated suction tube is to be bent, press the release button on the articulated
suction tube and bend the lower part forwards.
If it is to be folded up again, move the lower part back into the straight position. The
release button must be heard to engage in place.
24
• To detach it, press the release button (13) and pull the
electrical fl oor nozzle or the articulated suction tube out
at the same time.
• Removing: Twist the dust container (20) a little bit. It is re-
leased from the motor unit (17) and can be removed.
• Inserting: Insert the dust container into the motor unit. Ro-
tate it slightly as you do this until it engages in the motor unit
correctly. Then twist the dust container in the motor unit to
secure it in place. The release button of the dust container
must be located below the suction opening (21) after it has
been attached.