Cleaning And Care; Emptying The Dust Container; Cleaning The Motor Filters - DS Produkte 09109 Mode D'emploi

Cleaning and Care

PLEASE NOTE!
■ Empty the dust container when it is full up to the MAX marking, and regularly clean
all fi lters to prevent the motor from overheating.
■ Do not clean the fi lters with water!
■ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the de-
vice. These could damage the surfaces.
The fi lters may lose some of their colour over time. This is normal and does not
have any adverse effect on function.

Emptying the Dust Container

1. Press the release button of the dust container and pull it out of the device by the
handle.
Inserting the Dust Container into the Device
1. Grip the dust container by the handle and fi rst insert the bottom of the container into
the device.
2. Press the handle against the device housing until the dust container audibly engages
in the locking catch.
3. Lift up the device by the dust container handle to check whether the dust container
is in the correct position.

Cleaning the Motor Filters

The device has two motor fi lters which fi t on the dust container.
1. Remove the dust container from the device and empty it (see "Emptying the Dust
Container").
C
2. Pull the fastening tab (B) on the dust container lid forwards
B
and pull the dust container lid upwards.
3. Hold the dust container over a dustbin and tip it out.
Clean the dust container regularly with a damp cloth and
then dry it thoroughly.
4. Insert the dust container lid into the locking lug on the front
of the dust container and then press it down. The fastening
tab must be heard to engage in place.
2. Pull on the tab (C) and remove the fi lter holder.
3. Remove the foam fi lter from the fi lter holder.
Please Note: The HEPA fi lter is attached to the fi lter hold-
er and cannot be taken out of the holder!
4. Tap out both motor fi lters and brush off any loose dirt.
IMPORTANT: Do not clean the motor fi lters with water!
21 EN