Troubleshooting - DS Produkte 09109 Mode D'emploi

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps below, contact the customer
service department.
Do not attempt to repair a defective electrical device yourself!
Problem
The device cannot
be switched on.
The fuse in
the fuse box is
triggered.
The performance is
weak.
Dust escapes from
the device during
cleaning.
The mains cable
cannot be wound up
fully.
23
Possible cause
The mains plug is not in-
serted correctly in the plug
socket.
The plug socket is defective.
No mains voltage is present.
Too many devices connected
to the same circuit.
Is the exhaust air valve in the
handle open?
Is the dust container too full?
Are the fi lters or the device
dirty?
Is the nozzle, the telescop-
ic tube or the suction hose
clogged?
The On / Off switch is set to
MIN.
Is the dust container not
closed correctly and / or not
(correctly) inserted into the
device?
Are the fi lters or the device
dirty?
The mains cable was not cor-
rectly wound up in the device.
Fix
Insert the mains plug.
Try another
plug socket.
Check the fuse of the mains
connection.
Reduce the number of devic-
es in the circuit.
Close the exhaust air valve.
Empty the dust container.
Clean the dust container, the
motor fi lters and the HEPA
exhaust air fi lter.
Switch off the device, pull
the mains plug out of the
plug socket and remove the
blockage.
Turn the On / Off switch
towards MAX to increase the
suction force.
Close the lid or correct the fi t
of the dust container.
Clean the dust container, the
motor fi lters and the HEPA
exhaust air fi lter.
Pull the mains cable out a
little and press the
for winding up the cable.
EN
button