Troubleshooting - DS Produkte 06805 Mode D'emploi

■ Do not use any chemical cleaners to clean the device. They could damage the device.
■ The water tanks have to be emptied and rinsed out before you put away the device.
1. Make sure that the mains plug is pulled out.
2. Empty the dirty water reservoir (11). To do so, fold up the hand and pull the reservoir
out of the base (10) of the device.
10. Remove hair and dirt from the brush on the bottom of the device. To do so, lay the
device horizontally on the fl oor. Pay attention that the dirty water and the fresh water
reservoirs are empty or have been taken out. The water could leak out of the water
reservoirs.
11. Let all parts of the device (even the brush on the bottom of the device) dry completely
before storing it.

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the
problem yourself. If the problem cannot be solved with the steps that are listed, contact
the customer service department.
Do not attempt to repair a defective electrical device yourself!
Problem
The device is not functioning.
09840_DE-EN-FR-NL_A5_V3.indb 19 09840_DE-EN-FR-NL_A5_V3.indb 19
19
3. The cap is on the back of the reservoir. Turn it 90 °
counterclockwise to open it.
4. Pour out the dirty water and rinse the reservoir out
thoroughly with warm water (max. 40 °C).
5. The exhaust air fi lter is located at the top of the dirty water
reservoir. Press the locking mechanism outward toward
the fi lter and remove the fi lter mount.
6. Take the fi lter out of the holder and rinse it off with warm
water.
7. Take the protective motor fi lter out of the main unit and
rinse it off with warm water.
8. Pour the leftover cleaning solution out of the fresh water
reservoir and clean the reservoir thoroughly with warm
water (see chapter "Use" | " Preparing the Device / Filling
the Fresh Water Reservoir").
9. As required, wipe down the device with a moist cloth.
Potential cause / solution
• Is the plug properly connected with the socket?
• Is the socket defective? Try another socket.
• Check the socket's fuse.
EN
13.12.2017 15:58:34 13.12.2017 15:58:34