Cleaning The Device And Accessories; Emptying The Dust Bin And Cleaning The Fi Lter - DS Produkte PC-P002-1 Mode D'emploi

Cleaning the device and accessories

ATTENTION!
❐ After every use, clean the fi lter to prevent the suction power from diminishing and to
prevent the motor from overheating.
❐ Before you clean the device, switch it off and make sure that it is not connected to
the power supply.
❐ Keep the main unit, charger and cable away from water or other liquids in order to
prevent electrical shocks. When cleaning, make sure that no liquids penetrate the
main unit. Only the dust bin, the insert, the fi lter and the suction nozzles may be
cleaned with water. However, those parts must be completely dry when inserted in
the device.
❐ The fi lter is not suitable for the washing machine, dishwasher or dryer! Only air dry
the fi lter; do not in any case use a hair dryer.
❐ Do not use any abrasive or scouring cleaners or cleaning pads to clean the device
and accessories. They could damage the surface.
• The dust bin must be emptied after every use or no later than when it has been fi lled
up to the corresponding mark (see section "Emptying the dust bin and cleaning the
fi lter").
• If needed, clean the casing with a damp, soft cloth. Dry it off with a soft cloth.
• Regularly remove hair and lint from the nozzles.
• Check the charger and its power cord regularly for damage.
• Keep the device operational. Charge the storage battery after every use (see chapter
"Charging the storage battery").
The fi lter may discolour over time. This is normal and does not affect the func-
tionality. If, however, it is damaged or worn, it must be replaced. You can reor-
der a new fi lter at www.service-shopping.de.
Emptying the dust bin and cleaning the fi lter
1. Switch the device off.
5. Allow all parts to air dry completely before assembling them. ATTENTION: Do not in
any case put the fi lter and insert back in place if they are still wet. Reverse the
steps to assemble them.
2. Carefully take the dust bin off of the main unit (see chapter
"Assembly", section "Removing / inserting the dust bin").
3. Pull the insert and fi lter out of the dust bin.
4. If you have vacuumed up dry dirt, empty the dust bin in a
garbage bin. Tap out the insert and fi lter over the garbage
bin. If wet dirt is located in the dust bin, rinse these parts
off under running water.
23