Cleaning The Device; Emptying And Cleaning The Dust Container - DS Produkte ZW-9021-E085 Mode D'emploi

Cleaning the Device

CAUTION!
❐ Empty the dust container if it is full and clean the fi lter regularly to prevent overhea-
ting of the motor.
❐ Always remove the mains plug from the plug socket before doing any cleaning of
the device.
❐ Keep the device, the cable and the mains plug away from water or other liquids in
order to avoid electric shocks. Make sure that no liquid gets into the device during
cleaning. Only the plastic dust fi lter and the exhaust air fi lter may be cleaned with
water. However, they must be completely dry before they are put back into the device.
❐ Never clean the dust fi lter in the dust container lid using water or other liquids!
❐ The fi lters are neither machine-washable, dishwasher-safe nor suitable for tumble
drying! Only ever dry the fi lters in the air, and never use a hair dryer to do so.
❐ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the
device. These could damage the surfaces.
• Clean the dust fi lter, the plastic dust fi lter and the exhaust air fi lter regularly, or if you
notice a reduction in the suction power.
• Clean the housing if necessary using a damp, soft cloth. Dry it with a soft cloth.
• Remove hair and fl uff from the nozzles at regular intervals.
The fi lters may lose some of their colour over time. This is normal and does not
have any adverse effect on function.

Emptying and Cleaning the Dust Container

1. Detach the suction hose from the dust container (see „Assembly" chapter, „Inser-
ting/Removing the Hose" section).
All manuals and user guides at all-guides.com
2. Press the release button of the dust container and pull it
up out of the device by the handle.
3. Hold the dust container over an open dustbin. The distance
between the dust container and the dustbin should be as
short as possible to ensure that the dust from the dust
container falls into the dustbin only and does not spill into
the environment.
4. Press the button to open the dust container. The bottom
of the dust container will open and the dirt will fall out.
5. Close the bottom of the dust container again. The faste-
ner must be heard to engage in place.
6. If necessary, you can rinse the dust container and the plas-
tic dust fi lter with clear, lukewarm water. Turn the dust con-
tainer lid to remove it from the dust container. NOTE: On
the dust container and its lid there are arrows and closure
markings to make it easier for you to remove and attach
the lid. The lid can be removed when the marking on the
lid points to the opened lock symbol on the dust container.
27