Cleaning The Dust Filter - DS Produkte ZW-9021-E085 Mode D'emploi

Cleaning the Dust Filter

The dust fi lter is located in the dust container lid.
1. Detach the suction hose from the dust container (see „Assembly" chapter, „Inser-
ting/Removing the Hose" section).
(D)
(E)
5. Only place the foam fi lter back into the dust fi lter when it is completely dry.
6. Insert the dust fi lter in the dust container lid.
7. Close the dust container lid. Make sure that the latch on the dust container lid is
locked in place correctly.
8. Place the dust container into the device: Hold it by the handle and place the bot-
tom of the container into the device fi rst. Then push the handle against the device
housing until the dust container is heard to lock in place. Hold the device by the
handle and lift it to check that the dust container is in the correct position.
All manuals and user guides at all-guides.com
2. Open the dust container lid by releasing the catch on the
handle and fl ipping up the lid.
3. The dust fi lter is located in the dust container lid. Remove
the dust fi lter for cleaning.
4. The back of the dust fi lter (D) consists of a black foam fi l-
ter (E) which can be removed. Tap out the contents of the
dust fi lter over a dustbin and brush off the loose dirt. If
necessary, wipe the dust fi lter using a damp cloth. As re-
quired, rinse the foam fi lter (E) using clear, lukewarm wa-
ter. CAUTION: Never clean the foam fi lter in a washing
machine or dishwasher! Then press out the fi lter and
allow it to dry completely in the air before reinserting it in
the dust fi lter.
29