Emptying And Cleaning The Dust Bin; Cleaning The Dust Fi Lter And The Foam Fi Lter - DS Produkte VC-TC 3503-1 Mode D'emploi

Emptying and cleaning the dust bin

1. Remove the suction hose from the dust bin (see chapter "Assembly", section "Inser-
ting/removing the hose").
7. When the dust container is completely dry, screw the dust container lid fi rmly back
onto the dust container.
8. Place the dust container into the device: Hold it by the handle and place the bot-
tom of the container into the device fi rst. Then push the handle against the device
housing until the dust container is heard to lock in place. Hold the device by the
handle and lift it to check that the dust container is in the correct position.
Cleaning the dust fi lter and the foam fi lter
1. Remove the suction hose from the dust bin (see chapter "Assembly", section "Inser-
ting/removing the hose").
2. Push the release button on the dust bin and pull it out of
the device by the handle.
3. Hold the dust bin over an open garbage bin. The dust bin
should be as close as possible to the garbage bin so that
dust from the dust bin only falls into the garbage bin and
is not dispersed in the surrounding area.
4. Push the release button to open the dust bin. The bottom
of the dust bin will open and the dirt will fall out.
5. Shut the bottom of the dust bin again. The fastener must
audibly lock into place.
6. If you need to clean the dust container, you have to remo-
ve the dust bin cover fi rst by turning it and pulling it off. If
necessary, thoroughly rinse the dust container with clear,
lukewarm water. CAUTION: Do not under any circum-
stances clean the dust container in a washing machi-
ne or dishwasher! Then shake off any excess water and
allow the dust container to dry completely in the air.
2. Push the release button on the dust bin and pull it out of
the device by the handle.
28