Cleaning The Exhaust Air Filter; Storage - DS Produkte VC-1101-S-3 Mode D'emploi

9. After drying, place the foam fi lter back into the HEPA fi lter and place it into the cyclone
insert. PLEASE NOTE: Do not place the cyclone insert, HEPA fi lter and foam
fi lter into the dust container if one of the components is still damp!
10. Place the cover on the dust container and rotate it as far as it will go.
11. Place the dust container into the device.
If the HEPA fi lter is damaged or worn, you can order a new fi lter at:
www.service-shopping.de

Cleaning the Exhaust Air Filter

The exhaust air fi lter is located on the rear of the vacuum cleaner behind a protective grille. It
fi lters the air as it leaves the vacuum cleaner and before it is returned to the ambient air. Clean
the exhaust air fi lter from time to time.
1. Press the button in the middle of the protective grille and remove the grille.
2. Take the holder of the exhaust air fi lter out of the device and the exhaust air fi lter out of
the holder.
3. Tap the exhaust air fi lter out over a dustbin. If necessary, you can also clean it with clear,
lukewarm water. Then shake off any excess water and let the fi lter dry completely in the air.
PLEASE NOTE: Never install the fi lter as long as it is still damp!
4. Brush off or wipe down the exhaust air fi lter compartment if necessary.
5. Place the exhaust air fi lter into the holder and the holder back into the fi lter compartment.
6. First engage the protective grille in the recesses at the bottom of the fi lter compartment,
then fold it until it engages.

Storage

• For practical storage purposes, you can hook the fl oor nozzle into the bracket on the back
of the device and collapse the telescopic tube as far as possible.
• Store the vacuum cleaner in a cool, dry indoor room that is inaccessible to children and pets.
27