Cleaning The Motor Fi Lter; Cleaning The Exhaust Fi Lter - DS Produkte PC-C001-5 Mode D'emploi

3. Push down on the dust bin fastener. The container lid will open and you can empty the
container.
4. Close the lid of the dust bin. The fastener must lock into place. Help closing the lid if ne-
cessary by pushing the fastener up against the dust bin lid.
C
D
Cleaning the motor fi lter
1
D
Cleaning the exhaust fi lter
1. Open the exhaust fl ap on the back of the vacuum cleaner. The exhaust fi lter is located
behind the exhaust fl ap.
2. Remove the exhaust fi lter.
3. Shake out the fi lter over an open garbage can.
09065_DE-GB-FR-NL_V0.indb 21 09065_DE-GB-FR-NL_V0.indb 21
All manuals and user guides at all-guides.com
5. Depress and hold the release button and put the dust bin back
in the vacuum cleaner. The dust bin has been properly posi-
tioned when the release button pin (C) is located under the
bracket (D) on the vacuum cleaner housing (see fi gure).
1. Remove the dust bin (see section "Emptying the dust bin").
The motor fi lter (1) is located behind the dust bin in the vacu-
um cleaner housing. It is protected by a foam fi lter.
2. Remove the foam fi lter.
3. Turn the frame with the fi lter counterclockwise and remove
it. Reach into the two recesses on the frame in order to ro-
tate and remove the frame.
4. Shake out the fi lter over an open garbage can.
5. If needed, clean the fi lter with clear, lukewarm water and al-
low it to dry completely. Do not insert the fi lter if it is still
moist.
6. Place the frame with the fi lter back in the vacuum cleaner
housing and turn it clockwise to secure it. Reach into the two
recesses on the frame as when removing it.
7. The motor fi lter is in place when the frame is fl ush with the
vacuum cleaner housing and the recesses on the frame are
perpendicular to the bracket (D) on the vacuum cleaner hous-
ing and are vertically in line with one another (see fi gure).
21
06.09.2013 08:12:08 06.09.2013 08:12:08