Cleaning The Carpet - DS Produkte VC9388 Mode D'emploi

Cleaning the carpet

ATTENTION!
❐ Do not use the device as a conventional vacuum cleaner.
❐ Always make sure that there is no risk of the device tipping over. The water could leak out
of the water tanks. To stow the device, position the handle in an upright position so that it
locks into place.
❐ Never leave the device on when unattended.
❐ Turn off the device before you remove a water tank.
❐ Do not excessively wet the carpet.
1. Determine where you want to start and stop cleaning without stepping on the area of the
carpet that was just cleaned. We recommend that right-handed persons start on the right
carpet border and left handed persons start on the left carpet border. Cleaning solution may
leak out of device once it is deactivated. For this reason, have a cloth laid out that you can
place the device on after use.
2. Completely unwind the mains cord from the hook (10), insert it in the cord bracket (14) and
connect it with an easily accessible socket whose mains voltage corresponds to the device's
technical data.
3. Push the On/Off switch (13) to the I position to turn on the device.
7. Now go over the same strip in reverse. The dirty water will be vacuumed up.
8. Start the next strip slightly overlapping the cleaned carpet strip. Work with even forward
and backward movements up to the other edge of the carpet. In the event of stubborn dirt,
go over a strip of the carpet several times if necessary.
9. Once the dirty water tank (7) fi lls up to the Max mark, it will have to be emptied (see chap-
ter "After use", section "Cleaning the device").
10. If you would like to empty the dirty water tank, fi ll the fresh water tank or end the cleaning
process, place the device on the cloth you laid out. Turn it off (switch set to 0) and bring the
handle to an upright position.
11. Remove the power plug from the socket.
4. Step on the pedal (12) and tilt the handle to a position that is
comfortable for you.
5. Run the device to a corner of the carpet.
6. Push the device forward along the carpet border and depress
the button for emitting the cleaning solution (9). This will apply
and brush the cleaning solution into the carpet. In the process,
walk next to the device. Do not step on the wet carpet!
Once you have arrived at the other end of the carpet, release
the button.
20