Use; Preparing The Carpet; Preparing The Device/Fi Lling The Fresh Water Tank - DS Produkte VC9388 Mode D'emploi

Use

Preparing the carpet

1. Thoroughly vacuum clean the carpet to be treated with a vacuum cleaner. Use a brush
adapter for this (if possible).
2. If possible, remove all furniture from the carpet. Place a plastic tarp under or around the
legs of large pieces of furniture that can't be moved aside and only remove the tarp once the
carpet is completely dry after cleaning. Otherwise the wet carpet could damage the legs.
3. Check the carpet's colour-fastness. Dip a piece of white fabric in the enclosed cleaning solu-
tion (see section "Preparing the device/fi lling the fresh water tank") and carefully rub it on a
hidden part of the carpet. If the white fabric does not discolour, you can clean the carpet with
the device. For multicoloured carpets, test every colour for colour-fastness.
Preparing the device/fi lling the fresh water tank
ATTENTION!
❐ Only fi ll the fresh water tank with the enclosed cleaner or with commercially-available carpet
cleaners for carpet washers.
❐ Do not use any high-foaming cleaners as an excessive amount of foam impairs the functioning
of the device.
1. Hold the fresh water tank (3) by the handle and depress the
release button (2). The tank will be released from the locking
mechanism.
2. Take the fresh water tank out of the device.
3. Unscrew the tank cap and fi ll it with carpet cleaner. Please fol-
low the dosing instructions for the cleaner.
4. Fill the fresh water tank with warm water (max. 40 °C) up to the
Max mark. Then put the cap back on the tank.
5. Mount the fresh water tank in the midsection. In the process,
fi rst insert the rubber connecting piece on the bottom of the
tank in the ring of the main unit. Then press the tank against the
top part of the midsection until it locks into place.
19