Before Fi Rst Use; Assembly; Mounting/Removing Suction Nozzles; Removing / Inserting The Dust Bin - DS Produkte PC-P002-1 Mode D'emploi

Charging station
Visit our website to reorder original spare parts/accessories:
www.service-shopping.de
Before fi rst use
ATTENTION!
❐ Keep children away from the packaging. There is, among other things, a danger of
suffocation!
1. Unpack all parts and make sure that the product contents are complete (see chapter
"Scope of delivery and device overview") and that there are no transport damages.
Comment: Please note that two nozzles can be connected with one another. If you
identify damages to the components, do not use them (!), instead contact our cus-
tomer service centre.
2. Pull any foils or stickers off of the device and accessories.
3. Charge the storage battery (see chapter "Charging the storage battery").

Assembly

Mounting/removing suction nozzles

Removing / inserting the dust bin

The vacuum cleaner can be stored and charged in the charging sta-
tion. It has holders on the side for the brush and tile nozzle. You can
set the charging station down or mount it on the wall.
• Insert the desired nozzle up to the stop point in the suction
opening on the front of the dust bin. Check to make sure
it is secure.
• To remove a suction nozzle, pull it out of the suction open-
ing.
• Removal: Hold the device with the dust bin down and take
hold of the dust bin. Push the button to release the dust bin
and take the dust bin off of the main unit.
• Insertion: A catch is located on the bottom edge of the main
unit. Insert it in the corresponding slit in the dust bin. Then
push the two parts of the device together at the top until
the locking mechanism audibly locks into place. If neces-
sary, the release button must be depressed in the process.
Then check whether the dust bin is properly seated.
19