Charging Station; Connecting The Charging Station - DS Produkte PC-P002-1 Mode D'emploi

Charging station

Place the battery-operated vacuum cleaner on the charging station when you are not
using it. If the charging station is connected to a power source, the storage battery will be
automatically charged and the vacuum cleaner is always operational.

Connecting the charging station

ATTENTION!
❐ Do not place or hang the charging station near a heat source (e.g. heater, oven,
stove)!
❐ Ensure that the cord does not pose a trip hazard!
You will need Phillips screwdriver. One mounting piece and six screws are in-
cluded in the product contents.
1. Turn the charging station upside down so the bottom is
facing up. Insert the charger's barrel connector in the
opening in the centre of the charging station.
2. Place the mouning piece with its bulge facing down on the
connector and screw it tight using the supplied screws.
3. Pull the charger cord through the slit on the edge of the
charging station.
4. Screw the cover the bottom of the charging station tight.
5. Place the charging station on a dry, stable surface or
mount it on the wall (see below).
6. Connect the charger to a properly installed, easily acces-
sible socket.
7. Place the battery-operated vacuum cleaner on the charg-
ing station. The storage battery will start to charge. Empty
the dust bin before you charge the device!
20