Cleaning And Storage - DS Produkte 06259 Mode D'emploi

When the device is switched on, the charge status of the battery (4) is indicated
by the two green battery charge status lamps (1). If both lamps are lit up, the
battery is full. If only the red operating lamp (1) is lit up, the battery needs to be
charged up.
1. Select an accessory as required (see the "Device Overview" chapter – "Accesso-
ries") and attach it to the device (see the "Assembly" chapter).
2. Switch the device on. This can be done in one of two ways:
– by gently holding the On / Off switch (2) down. The device will switch off when you
let it go.
– by fi rmly pushing the On / Off switch once and then releasing it. If you would like to
switch the device back off , push the On / Off switch again.
3. The device will immediately start to vacuum clean. The operating lamp and the
battery charges status lamps are lit up.
4. Run the device over the area to be cleaned.
5. After vacuuming, switch off the device.
6. To ensure that the device operates optimally, empty and, if necessary, clean the dust
container (7) after each use (see the next chapter).

Cleaning and storage

PLEASE NOTE!
■ Do not immerse the HEPA fi lter and the foam fi lter in water or rinse it under running
water to prevent damage. They are neither machine-washable, dishwasher-safe nor
suitable for tumble drying.
■ The fi lter holder is not suitable for the washing machine, dishwasher or dryer! Only
air dry the fi lter holder and do not in any case use a hair dryer.
■ Do not use any corrosive or abrasive cleaners to clean the housing. They could
damage the surface.
The HEPA fi lter may lose some of its colour over time. This is normal and does
not have any adverse eff ect on function.
Emptying the Dust Container and Cleaning the Foam Filter
closed
open
e
06259_07258_07833_09572_09847_DE-EN-FR-NL_A5_V14.indb 23 06259_07258_07833_09572_09847_DE-EN-FR-NL_A5_V14.indb 23
23
1. Remove the dust container (7) from the motor unit (3).
Turn it a little to do this. It is released from the motor unit
and can be removed.
2. Remove the foam fi lter from the top of the dust container,
tap it out and clean it with a soft brush if necessary.
3. Hold the dust container over an open dust container. The
distance from the dust container should be as small as pos-
sible so that the dust does not spread in the surrounding air.
4. Pull the catch of the bottom fl ap (e) away from the dust
container slightly. The bottom fl ap will open and the dirt
will fall out.
5. To close it, press the bottom fl ap onto the dust container.
The catch must be heard to engage in place.
EN
08.06.2021 16:15:33 08.06.2021 16:15:33