Use; Preparing The Room; Starting The Device; Cleaning, Maintenance Work And Storage - DS Produkte HZ-01 Mode D'emploi

Use

Preparing the Room

CAUTION!
■ If you are using the device in a room for the fi rst time, keep an eye on it in case you
need to remove any obstacles so that the device can effectively clean the entire room.
• Remove any objects from the fl oor that may get caught in the nozzle (13) or prevent
the device from cleaning. In particular, do not leave plastic bags on the fl oor.
• Make sure that no cables, cords, or fringes, for example from curtains or tablecloths,
are in the path of the device.
• Remove all objects that could be tipped over (e.g. vases, small lamps, decorations).
• The distance between two objects (e.g. wall and shelf) must be at least 40 cm so that
the device can get through.
• The device can get stuck under furniture which it can just about get under. Block its
path, for example, with fl ower pots that are heavy enough not to get knocked over.

Starting the Device

1. Make sure that the dust container (1) is empty, the device is free of any contamination
(see the "Cleaning, Maintenance Work and Storage" chapter) and the battery is
charged up.
2. If necessary, fi x a dust cloth to the attachment for the dust cloth (10) if you want to use
the device on hard fl oors, or remove the attachment for the dust cloth (see the "Using
the Dust Cloth" section) if you want to use the device on a carpet.
3. Place the robot vacuum cleaner on the fl oor.
4. To switch on the robot vacuum cleaner, move the On/Off switch (4) to position I.
5. To switch off the robot vacuum cleaner, move the On/Off switch to position 0.
6. After each use, empty the dust container and remove any contamination (see the
"Cleaning, Maintenance Work and Storage" chapter).

Cleaning, Maintenance Work and Storage

CAUTION!
■ During cleaning and maintenance work, the device must not be connected to the
mains power and must be switched off!
■ Only the dust container may be rinsed out. The device must not be immersed in water
or any other liquids. Make sure that all parts are completely dry before you insert the
dust container back into the device!
■ Do not use any caustic or abrasive cleaning agents for cleaning. These can damage
the surface.
1. Before and after every use, make sure that
– the nozzle and ventilation openings are clear,
– the sensors on the bottom of the device are clear of dust etc.,
21 EN