DS Produkte HZ-01 Mode D'emploi page 20

EN
To insert or remove the rechargeable battery, please proceed as follows:
Charging Up the Battery
– Do not charge up the rechargeable battery (9) of the device in damp locations
and make sure that the room temperature is between 15ºC and 35ºC.
– Completely discharge the rechargeable battery every few months and then
charge it up again. To discharge the battery, use the device with the charging
station disconnected from the mains without any cables until it comes to a
standstill. Then charge up the battery.
– Before you fi rst use the device, or if it has not been used for a long time, it
takes approx. 8 to 9 hours, later approx. 4 to 6 hours, for an empty battery
to be fully charged up. The battery only reaches its full performance capacity
after it has been fully discharged and recharged two to three
– The device cannot be switched on while it is still connected to the mains power.
1. Connect the mains adapter cable directly to the device.
2. Insert the mains plug of the mains adapter into an easily accessible socket.
3. The charging process then begins. The charging control lamp (7) lights up in red.
When the charging control lamp lights up in green, the battery is fully charged and
the device is ready for use.
4. Disconnect the device from the mains after around 4-6 hours.
Using the Dust Cloth
– To clean hard fl oors, use the dust cloth to remove both crumbs and dust from
the fl oor at the same time.
– To clean carpets, remove the attachment for the dust cloth.
1. The attachment for the dust cloth is already prefi tted when the device is supplied. All
you need to do is attach the dust cloth using the Velcro fastener.
2. If you do not want to use the dust cloth, remove it from the attachment.
3. Also remove the attachment for the dust cloth (10) by simply pulling it off.
4. If you then want to secure the attachment on again, fi rst place a locking lug into the
notch which is provided and then slide the second locking lug into the other notch
with a little pressure.
20
• Undo the screw, reach into the indentation and fl ip up the
battery compartment cover.
• Inserting: Attach the connectors and insert the battery
pack into the battery compartment. Close the battery com-
partment cover and tighten the two screws.
• Removing: Pull up the battery pack and release the plug
connection by pressing on the locking lug.
times..