Care; Troubleshooting - DS Produkte HZ-01 Mode D'emploi

EN
– the dust cloth has been cleaned or replaced,
– no hairs, threads, or similar things are wrapped around the wheels.
2. If necessary, just wipe down the housing with a damp cloth.
3. Pull the dust cloth off the dust cloth holder and wash it using warm water and mild
soap.
4. Remove the dust container:
– press the release buttons (2) on the device at the same time,
– pull out the dust container.
5. Open the dust container by fl ipping the locking lug forwards and pushing it up.
6. Empty the dust container over a rubbish bin.
7. Also clean the dust fi lter over a rubbish bin after each use. This is located inside the
dust container.
8. Clean the dust container if necessary with clear, warm water. Then allow it to dry
completely before you insert it back into the device. When you insert the dust
container, make sure that it fi ts correctly in the dust container compartment.
9. Reinsert the dust fi lter. When you insert the fi lter, make sure that it fi ts correctly!
10. Attach a clean and dry dust cloth to the dust cloth holder.
11. You should store the device and accessories in a dry, cool place which is protected
from sunlight and is out of the reach of children and animals.

Care

Material dust cloth: 100 % polyester
hand wash up to
max. 30 °C
do not dry in the
dryer
do not dry clean
• Only wash with a mild detergent.
• Do not use any softener.

Troubleshooting

If the device stops working properly, fi rst check whether you are able to correct the prob-
lem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does not
work.
The battery of the de-
vice is not charging.
22
do not bleach
do not iron
Possible cause / solution
• Is the battery charged up?
• Is the On/Off switch in position I?
• Check whether the mains adapter is correctly connected
to the plug socket.
• Is the mains adapter defective?
• Is the socket defective? Try another socket.
• Check the fuse of your mains connection.