Assembly; Use - DS Produkte Z 09391 Mode D'emploi

Unpack all parts and make sure that the scope of delivery is complete (see chapter "Device
overview and scope of delivery") and check for any damages from transport. If you identify
damages to the components, do not use them (!), instead contact our customer service.

Assembly

ATTENTION!
❐ The device must always be switched off when you want to assemble or disassemble
the device or replace the accessory nozzles.
Tip: All accessory nozzles can be directly mounted on the handle without being
extended by the telescopic tube.

Use

ATTENTION!
❐ During use, never hold the nozzles near body parts or animals and do not reach into
them. The device could attach itself to them and you could be injured. If the vacuum
cleaner attaches itself to the fl oor, turn it off immediately.
❐ Only turn the device on once you have determined that all parts have been completely
mounted and the dust bin and dust fi lter have been correctly inserted.
1. Insert the suction hose in the suction tube connection. It
must audibly lock into place. To remove the hose, push
the two catches on the side of the suction hose and at
the same time, pull it out of the suction tube connection.
2. Insert the telescopic extension tube in the handle. If you
would like to remove the telescopic tube at a later time,
simply pull it off the handle.
3. Push the telescopic tube lock towards the arrow. Hold
the slide lock in position and pull the telescopic tube to
the desired length. Let go of the slide lock so that the
telescopic tube lock can engage.
4. Select an accessory nozzle and connect it to the tel-
escopic tube. If you would like to remove the nozzles,
simply pull them off the telescopic tube.
19